|
|
|
| Insert second e-ring onto groove in axle and check assembly. Repeat procedure for the second side and check plunger and weight-spring assembly for free operation. Double check all e-rings for proper seating. | Reinstall governor and cover into trans. Use the supplied replacement gasket for TH-400, or O-ring for TH-350 and 700R4. Tighten TH-400 cover bolts to 15 ft-lbs. Install clip on TH-350 and 700R4. |
|
After everything is buttoned up drop the vehicle. Start and allow vehicle to warm up, and then check transmission fluid. Replenish any ATF lost in governor replacement. Test-drive the vehicle and record shift point RPM, and vehicle speed. It's best to make one change at a time, either a weight, or a spring – but not both at once. Don't be alarmed if shift points are not perfect the first try. |